Silicone modified epoxy coating with enhanced thermal resistance capabilities. Excellent for protecting outdoor structural steel, pipes, and equipment from corrosion. Withstands operating temperatures of up to 400°F (204°C). Adheres well to difficult surfaces such as brass or copper.
Siloxseal 385 Mid Temp Silicone Read More »
U-497 is a three-component, zinc-rich polyamide epoxy primer for use on metal substrates in severe corrosive or salt environments or anywhere the substrate requires cathodic-type protection from its primer. Designed for easy application by brush, roller or spray, it provides long-term corrosion protection. When paired with U-166, U-499 or U-111 as a topcoat, it provides
U-497 Zinc Rich Epoxy Primer Read More »
A two-component high-build, high-solids novolac epoxy, this proven U-Series™ topcoat is highly surface tolerant. It can be applied in damp environments; once it has air-cured – typically in 8 hrs – it may be returned to service in wet or even submerged environments. This topcoat provides good abrasion and chemical resistance, making it ideal for
U-498 Polyamide Epoxy Topcoat Read More »
Designed to be applied in many environments, even on damp surfaces, U-499 is a two-component polyamide epoxy with corrosion inhibiting pigments that helps prevent corrosion and attack from sea-water and chemicals. It will cure when cold, and when cured at normal temperatures, can be ready for immersion in as little as 8 hours.
U-499 Polyamide Epoxy Primer Read More »
U-571 is best suited to applications subject to spills and splashes of acids and bases, epoxy novolacs offer enhanced resistance to chemicals. The 100 percent solids formulation offers zero V.O.C., low odor, and a high-build finish.
U-571 100% Solids Novolac Epoxy Read More »
Two component, water-based penetrating epoxy sealer/primer for protecting concrete surfaces. Quick cure provides a short time to overcoat Low viscosity allows penetration into the pores of concrete for increased adhesion Can be used as a primer, or as a final coat sealer
WearCOAT 1020 WB Epoxy Primer Read More »
Two component, 100% solids, moisture vapor tolerant epoxy primer for use on mechanically prepared concrete floors. Excellent in lowering moisture vapor pressure prior to applying standard coatings Effective for lowering moisture vapor transmission under resilient flooring and tile
WearCOAT 1080 Moisture Mitigating Primer Read More »
Excellent water-based sealer yields a wet-look previously only achieved with solvent-based acrylic sealers. Low-odor, UV-resistant formula cures in as little as 4 hours. Helps keep water, salts and stains from penetrating while giving a dark, wet appearance. For indoor or outdoor use on concrete, rock or natural slate-type surfaces.
WearCOAT 3045 Darkening Sealer Read More »
Two component, 100% solids epoxy floor coating. Formulated for general industrial flooring as an excellent high-build mid-coat Can be pigmented or used clear Ideal for use as a broadcast binder for flake, sand, or quartz media Very high resistance to amine blush making it ideal for application in most environments Also available in a fast
WearCOAT 440 100% Solids Epoxy Read More »
Two component, 100% solids fast curing epoxy floor coating. Formulated for general industrial flooring as an excellent high-build mid-coat Can be pigmented or used clear Ideal for use as a broadcast binder for flake, sand, or quartz media Very high resistance to amine blush making it ideal for application in most environments Fast Set allows
WearCOAT 440FS 100% Solids Epoxy Read More »
©2024 Coatings For Industry, Inc.
